![[Laser cut and engrave] Easter Egg Hunt Board Game](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/2e9249f1-0b19-4ca9-9ff0-88dc37587d96?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Easter Egg Hunt Board Game
Instruction
Information
A Board Game designed for Easter Egg Hunting.
Designed using XCS v2 (Beta) and AI options.
Designed for fast cut
Instruction
Step1: Design Grid and basic settings
All design work in XCS.
Design the board by drawing a 200mm horizontal line.
Use Grid Array tool to copy the line 6 times 40mm apart
Create a Vertical line of 200mm and align to left of horizontal lines with alignment tool
Use Grid Array tool to copy the line 6 times 40mm apart
Group vertical and horizontal lines
Draw a square of 200 x 200mm and align horizontal centre and vertical centre
Now you should have approximately 5 x 5 40mm square blocks
Draw another square of 220mm x 220mm and align horizontal centre and vertical centre with blocks on screen.
Draw a square 40x40 mm
With grid snap on draw a circle with centre point on a corner of the 40x40 square with circle 15mm radius
Select circle and 40mm square
Use the subtract tool to get a quarter circle
Copy the quarter circle with grid tool to all 25 squares in the grid.
Step2: Create graphics with XCS built in AI engine
For the graphics in the blocks use the AI tool and request pictures of veld flowers, grass etc. Then also picture of Easter bunny and Easter eggs.
Dray a big X for the 1 block for a special prize. :)
Copy the graphics to the blocks as in pictures above
Step3: Create backboard with game instructions
Game instructions
Draw another square of 220 x 220mm. This will be the back board
Engrave the game instructions on this board and add some decorative graphics as you like.
Step4: Cutting and assembly
Cut the MDF as per settings above
Glue the “frame” to the back board with the instructions facing the back.
Congratulations.
You have created a Easter Egg Board Game!
