HomeTemplatesDecorSeasonal & Themes DecorHolidays Decor
mcjrotcdm
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Easter money holder

Instruction
Easter egg money holders.xcs
Easter egg money holders
.xcs
Application scenario
Laser (30min)
Machine & module
xTool S1
40W
Compatibles · 8
Material used
Birch Plywood
98
790
Information
      This is a money holder for Easter. It consists of 2 1/4 pieces of birch, words, egg and spacer are out of 1/8 birch
Instruction
1
Step1: Laser materials

Place ¼ inch birch on laser bed and run canvas 1. 
Place 1/8 inch birch on laser bed and run canvas 2. Use painters tape to collect letters.

2
Step2: Paint

Paint letters with green spray paint. 
Paint the egg with pink spray paint. 
Allow to dry.

3
Step3: Clean parts

Clean shoot off of parts. Using baby wipes.
 

4
Step4: Glue
  1. Glue spacer to back plate.
  2. Glue front to the back plate assembly.
  3. Glue letters and egg to the front piece. Clamp parts in place and allow to dry.

     
5
Step5: Package

Package as needed

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1

License

CC0