HomeTemplatesDecorSeasonal & Themes DecorHolidays Decor
Ondrashek
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Easter Bunny Egg Holder

Easter Bunny Egg Holder.xcs
Easter Bunny Egg Holder
.xcs
Application scenario
Laser (30min)
Machine & module
xTool S1
10W
Compatibles · 7
Material used
Poplar Plywood
148
884
Information
      For bending poplar plywood I used hot tap water and carefully bend it and let it dried with a clips. After that you can glue bottom part and rear part and glue "basket" to the stand. When basket is glued to the stand you can glue basket to bunny. Insert egg to the basket and glue paper straps to the stand.
Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1
Poplar Plywood
Poplar Plywood

License

CC BY-NC-SA