HomeTemplatesFashion & WearablesJewelry
kerisvoboda
Report
[Laser cut and engrave] Melting Vinyl Earrings
Project made with xTool F1 machine for Laser cut and engrave.
Project made with xTool F1 machine for Laser cut and engrave.
[Laser cut and engrave] Melting Vinyl Earrings
Project made with xTool F1 machine for Laser cut and engrave.
[Laser cut and engrave] Melting Vinyl Earrings
Project made with xTool F1 machine for Laser cut and engrave.
[Laser cut and engrave] Melting Vinyl Earrings
Project made with xTool F1 machine for Laser cut and engrave.
[Laser cut and engrave] Melting Vinyl Earrings
[Laser cut and engrave] Melting Vinyl Earrings
[Laser cut and engrave] Melting Vinyl Earrings
[Laser cut and engrave] Melting Vinyl Earrings
[Laser cut and engrave] Melting Vinyl Earrings
[Laser cut and engrave] Melting Vinyl Earrings
[Laser cut and engrave] Melting Vinyl Earrings

Melting Vinyl Earrings

Melting-Vinyl-Earrings.xcs
Melting-Vinyl-Earrings
.xcs
Application scenario
Laser (5min)
Machine & module
xTool F1
10W
Material used
Transparent Acrylic
186
2374

Information

      For this piece, I used two different types of materials.  I used 3mm thick Red opaque acrylic from Glowforge and green acrylic sheet from xTool.  I am making it for a friend that I'll be visiting soon.  When cutting the thicker acrylic make sure that you always engrave first (Blue light, 30% power, 50 speed, 1 pass, 200 lines per cm, bi-directional) and then cut after (100% power, 3 speed, 2 passes).  I can't quite remember what I used for the thinner green sheet, but the settings were fairly fast, likely close to 1000 speed.  Good luck!
Comments

Remixes

xTool Supplies Used in This Template

xTool F1
xTool F1

License

CC BY-NC