HomeTemplatesDecorSeasonal & Themes DecorHolidays Decor
benhast24
Report
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Happy Easter picture frame :)

Instruction
Happy Easter.xcs
Happy Easter
.xcs
Application scenario
Laser (30min)
Machine & module
xTool D1 Pro
10W
Compatibles · 8
Material used
3mm Basswood Plywood
5
321
Information
      This is a picture for My Aunt saying "Happy Easter" and has a rabbit and palms on it symbolizing the wonderful Holiday, of Easter. Easter the celebration of Christ's resurrection.
Instruction
1
Step1: Gather Your Materials
Preview
Preview

You will need Glue, 1/8in thick Basswood Plywood, and Q-tips to apply the glue.

2
Step2: Laser cut and engrave Your Basswood Plywood.
Preview
Preview

Use the XCS file or copy the settings above to laser.

3
Step3: Next step glue the frame piece (the rectangle cut out) to the picture engraving (the front)
Preview
Preview
Preview

After you apply glue to the rectangle piece you can place and center it on the engraving and add pressure, I used heavy materials to hold them together.

4
Step4: Adding the back piece (the stand)
Preview
Preview

to add the stand just glue it to the back center of the engraving, making sure it is level on flat surfaces and on its back, the engraving will be on a slight angle upwards, and this is intentional for good looks.

5
Step5: Finished, just remove access glue and Your Done :)
Preview

remove any access glue and Your Done :) thank you!

Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY