HomeTemplatesDecorHome DecorDesk Decor
WM Laser Creations
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

We The People

Instruction
49.svg
49
.svg
Application scenario
Laser (60min)
Machine & module
xTool S1
40W
Material used
Stainless Steel Tumbler kit with Handle Seafoam
395
2283
Information
      Full 20 oz tumbler wrap of we the people and the constitution
Instruction
1
Step1: Prep Cup

Clean the cup with either rubbing alcohol or soap and water 

2
Step2: Measure the cup

Measured the cup with the tape that was supplied with the RA2 tool. Got my perimeter and entered it into XCS. Drew a Box in the software of the size of the cup and brought svg file in and sized accordingly. 

3
Step3: Choose settings for engraving

I had already done test grids on these cups, My settings for this cup was 40p, 500sp, 240lps. 1 pass.

4
Step4: Clean cup after engrave

Removed the cup and cleaned it with soap and water and a magic eraser. This cleans all of the charring if there is any.

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1
Stainless Steel Tumbler kit with Handle Seafoam
Stainless Steel Tumbler kit with Handle Seafoam

License

CC BY-NC-SA