1. Get ready for this project. A white tile. A spray can of Zinc cold galvanized.
2. A bottle of glue and a sticky hanger.
3. Magic sponge

Spray the tile vertically with Zinc Cold Galvanized spray. About 30 cm from the tile. Then again horizontally. Now let the tile dry thoroughly. When you pick up the tile, do so carefully because the Zinc cold galvanized spray can come off easily.

1. Place the tile in the M1. (When you pick up the tile, do so carefully as the Zinc cold galvanized spray can come off easily.)
2. Draw a square and align it with the tile you placed in the M1. (You can move the square to another layer that is more visible on dark, e.g. yellow). Set output to off for the square. 
3. Now insert the picture. Select the square and hold the shift key and click on the image. Then click on align horizontal and align vertical.
4. Click on the image and set the image to engrave. The settings are 40% power and 125 speed, 100 lines, 1 pass. 
5. Then click on frame to check whether the picture fits correctly on the tile.
6. Then click process
7. When the engraving is finished, remove the tile from the M1. Rub the Zinc cold galvanized spray off the tile. Take a white magic sponge and remove the rest under the water tap.
8.  On the back of the tile, stick the adhesive hanger at the top, exactly in the middle.