HomeTemplatesToys & Games & ModelsBoard Games
PILED
Report
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Chess Board

chess.xcs
chess
.xcs
Application scenario
Laser (10min)
Machine & module
xTool F1
10W
Material used
Eucalyptus red-faced plywood
PLA
103
900
Information
      10x10 grid for chess boards

I've uploaded a chess board pattern as a .xcs, .png and .svg

I used a pre-cut 10x10cm board however this can easily be resized to any sized board. 

Measure the base of the largest chess piece you wish to use then make the squares a few mm larger. I used 10mm squares with 8mm pieces I designed and 3D printed. The chess piece 3D models shown can be downloaded here: https://than.gs/m/1021866?affiliateCode=PILED

I used this jig to guarantee alignment: https://than.gs/m/972004?affiliateCode=PILED
Comments
Remixes
xTool Supplies Used in This Template
xTool F1
xTool F1

License

CC BY-NC-SA