Report
![[Laser cut and engrave] The Lord Prayer Cross](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/ed973cd2-455c-4ffe-b3a3-6d075cbc07b6?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
The Lord Prayer Cross
InstructionM1 Our Father cross
.xcs
Show 1 more
Application scenario
Laser (40min)
Machine & module
xTool M1
10WMaterial used
Birch Plywood
1120
5126
Information
The following project is made with M1 and D1 Pro on a 3mm Plywood. Easy assembly.
Instruction
1
Step1: Open xcs file.
Preview
Place your wood panel on the base. Preferably if you do have a honeycomb and air-assist as it will work much quicker on the cutting.
2
Step2: Resize the file.
Resize the file. Press refresh so the camera will capture an image of the wood panel.
3
Step3: Set your parameters and select laser flat.
Preview
Do select on the parameters eg. 60% and 6mm/s 1 pass. Do run your test grid so you have an idea where to start.
4
Step4: Press process and preview.
Preview
Preview
Preview
For XCS 2.0 a laser trajectory will appear on the preview screen. That shows how the laser module travel. Run framing make sure the laser module is within the wood panel.
5
Step5: Laser completed.
Preview
Open cover make sure all the lines fully cut.
6
Step6: Assemble the parts.
Preview
There are only 3 parts proceed to assemble with glue on the bottom of 2 panels.
7
Step7: Spray paint / brush
Preview
Use any of your favourite paint either you can spray or brush with any acrylic paint.
Let dry.
Comments
