Report
![[Laser cut and engrave] Stainless Steel Dogtag MOPA Color Test Grid | Speed * fine Power](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/6b440338-5565-40aa-8ee0-c6bc1c73c76f.JPG?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Stainless Steel Dogtag MOPA Color Test Grid | Speed * fine Power
InstructionColorfulDogtag%
.xcs
Application scenario
Laser processing
Machine & module
xTool F2 Ultra
40W, 60WCompatibles · 7
Material used
Stainless Steel Military Pendant (Keychain, Necklace)
16
Information
On this file I explored 500/600/700 mms in a finer power graduation.
Make sure you defocus the Laser, so the heating is more even, and the finish has less of an influence on the outcome.
Instruction
1
Step1: Load the XCS
Load the XCS and go through the usual focusing and alignment,
then make sure to defocus the laser by adding 0,3mm to your Z height.
You may wanna change the processing mode to “by Layer” to use the more spread out pattern I made using the different layers, to have heat be more predictable.
Comments
