Report
![[Laser cut and engrave] Laser Engraved Color Test Calibration Card for 3D Printing](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/7a3f032c-74e4-4502-ab58-a748ecfcd0bd.JPG?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Stainless Steel Dogtag MOPA Color Test Grid | Speed * KHZ
InstructionColorfulDogtagkhz
.xcs
Application scenario
Laser processing
Machine & module
xTool F2 Ultra
40W, 60WCompatibles · 7
Material used
Stainless Steel Military Pendant (Keychain, Necklace)
1
18
Information
Make sure you defocus the Laser, so the heating is more even, and the finish has less of an influence on the outcome.
Instruction
1
Step1: Load the XCS
Load the XCS and go through the usual focusing and alignment,
then make sure to defocus the laser by adding 0,3mm to your Z height.
You may wanna change the processing mode to “by Layer” to use the more spread out pattern I made using the different layers, to have heat be more predictable.
Comments
