HomeTemplatesMiniaturesDollhouse
Rainman229
Report
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Dollhouse

Instruction
DOOLHOUDE-1ST FLOOR BASE.xcs
DOOLHOUDE-1ST FLOOR BASE
.xcs
Application scenario
Laser (300min)
Machine & module
xTool D1 Pro
40W
Material used
Bass Wood（8mm）
72
984
Information
      Dollhouse large scale floors are 9" tall so it stands in at around 30inches tall.
Will need extended bed to make
Instruction
1
Step1: 1st floor

 

 

  1. Lay floor out on first floor

2. Lay wall out to the slots. each wall should have labels.

3. Glue inner wall to floor 

4. Glue out main wall to base and inner wall

5. Glue Outer walls on 

2
Step2: 2nd Floor
  1. Glue 2nd floor to the wall of the 1st floor 

2. Lay wall out to the slots. each wall should have labels.

3. Glue inner wall to floor 

4. Glue out main wall to base and inner wall

5. Glue Outer walls on 

 

3
Step3: Porch
  1. this one was tricky. 
  2. test fit them to make sure their location is correct. 
  3. then glue them to the handrail 
  4. then glue it to the rest 
4
Step4: Attic
  1. Lay floor out on attic floor
  2. glue floor down 

 

5
Step5: roof and trusses

1. lay roof out upside down.

2. lay wall out 

3 match tabs on trusses to wall (one side is slightly offset)

4. glue wall to 1 roof on (outside of roof has a small overhang) 

5. glue trusses on

6. glue 2nd roof on staring from the wall. as the trusses are more forgiving. 

7. glue roof assembly to house wall first 

 

 

Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro

License

CC BY-NC-SA