HomeTemplatesDecorHome DecorShelves & Holders
mrskconnolly
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Bunny Playdough holders

Instruction
Playdoughbunnies.xcs
Playdoughbunnies
.xcs
Application scenario
Laser (7min)
Machine & module
xTool S1
40W
Compatibles · 9
Material used
3mm Basswood Plywood
25
444
Information
      I created 2 play dough bunnies to include in toddler Easter baskets. You could edit the font and customize the bunnies. You can also include the following puns instead or as well. 

Play dough Puns:
I DOH not know what I'd do without you!
Have a DOH-riffic Easter!
Some bunny loves you (not a pun but would still be cute)

This is a pretty straight forward file. The two cut lines are the perimeter and the inside circle which holds a mini playdough.  I purchased a bulk pack during Halloween and use them to hand out as treats all year round!
Instruction
1
Step1: Cut/Burn File
Preview

This is a very basic project. There are 3 layers to this project, 2 bunnies.  I cut each bunny seperately because this is the first file I have ever made so I wanted to make sure I had the settings correct. The three layers are labeled cut, engrave and 2nd bunny. The cut settings are 90% power, 15mm/s speed, and 1 pass, the engraving is set to 30% power, 200mm/s speed, 1 pass. It took longer than expected to engrave.  The font used in the project was Aubrey downloaded from Dafont. It takes about 8 minutes to engrave and cut each bunny. You can customise the words with a name or other funny puns. 

Playdough puns:

I DOH not know what I'd do without you. 

Have a DOH-riffic Easter

Some bunny loves you! (not a pun but cute?)

The finished bunny is 113mm tall x 68 mm wide (4.44 “ x 2.67”)

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC-SA