HomeTemplatesHome DecorBox
Benkei
Report
[Laser cut and engrave] Spardose / Box / Money box
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] Spardose / Box / Money box
[Laser cut and engrave] Spardose / Box / Money box
[Laser cut and engrave] Spardose / Box / Money box
[Laser cut and engrave] Spardose / Box / Money box

Spardose / Box / Money box

Instruction
GönnerBox.xcs
GönnerBox
.xcs
Application scenario
Laser processing (45min)
Machine & module
xTool M1
10W
Compatibles · 11
Material used
1/8" Basswood Plywood
1/8"(3mm) Basswood Plywood
5

Information

      Eine einfache Sparbox für kleine oder große gönnungen. Am besten getrennt von der Familien Spardose aufbewahren! haha  
---
A simple savings box for small or large treats. Best kept separate from the family piggy bank! haha

Instruction

1

Step1: Download and Like ;D

Spardose / Box / Money box instruction: step 1 - Download and Like ;D
Preview

Downloadet euch die Datei und passt sie euch ggf. nach eurem belieben an.
Oder legt einfach los.

Download the file and customize it as you see fit.
Or just get started.
 
2

Step2: Anpassung / Adjustment

Spardose / Box / Money box instruction: step 2 - Anpassung / Adjustment
Preview

Bei meinem ersten Versuch musste ich die Verbindungen mit einem Cuttermesser anschrägen, sie waren etwas zu breit. Habe die Löcher minimal verbreitert so das alles passen sollte. Bitte gebt mir in den Kommentaren ein kleines Feedback ob alles gut passt oder ob ich etwas ändern kann. Ich danke euch!

Ansonsten wünsche ich euch viel spaß beim sparen!

On my first attempt, I had to bevel the joints with a utility knife; they were a bit too wide. I widened the holes slightly so everything should fit. Please give me some feedback in the comments if everything fits well or if there's anything I can change. Thank you!
On my first attempt, I had to bevel the joints with a utility knife; they were a bit too wide. I widened the holes slightly so everything should fit. Please give me some feedback in the comments if everything fits well or if there's anything I can change. Thank you!
On my first attempt, I had to bevel the joints with a utility knife; they were a bit too wide. I widened the holes slightly so everything should fit. Please give me some feedback in the comments if everything fits well or if there's anything I can change. Thank you!
On my first attempt, I had to bevel the joints with a utility knife; they were a bit too wide. I widened the holes slightly so everything should fit. Please give me some feedback in the comments if everything fits well or if there's anything I can change. Thank you!
Otherwise, I wish you lots of fun saving!
Comments

Remixes

xTool Supplies Used in This Template

xTool M1
xTool M1
1/8" Basswood Plywood
1/8" Basswood Plywood
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood

License

CC BY-NC