Report
![[Laser cut and engrave] Laser Cut Cute Bat Wooden Ornament with Night Forest Background](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/519e22ef-f1d4-4ee5-8fd6-92df3bb5d001.jpeg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Laser cut cute bat wooden hair tie
Instructionchild_bad_hair_tie
.xcs
Application scenario
Laser processing
Machine & module
xTool M1 Ultra
20WCompatibles · 11
Material used
1/8" Basswood Plywood
1/8"(3mm) Basswood Plywood
7
Information
I drew this little bat in Adobe Fresco for my kids and thought it would make a cute hair tie for the Halloween time. Hope you like it.
Instruction
1
Step1
Preview
Load the project into xTool Studio. Set the material to basswood plywood and start the process. You should end up with the four parts shown in the picture.
2
Step2
Preview
Add glue to the non-engraved bat part. Note that the bat is not perfectly symmetrical, so check which side fits the engraved part before applying glue.
3
Step3
Preview
Glue both bat parts together. Make sure to clean up any areas where the glue has leaked. I like to do that with wet wipes.
4
Step4
Preview
Add glue to the two U-shaped parts and attach them together. Again, make sure to clean up any leaking glue.
5
Step5
Preview
Insert the hair tie into the U-shape and carefully apply some glue to the ends. Then insert the ends of the U-shape into the matching slot on the back of the bat pieces.
Comments
