![[Laser cut and engrave] Laser Cut Wooden Model Airplane with Propeller and Star Engraving](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/0b8a29a5-40df-4de3-b2da-837d3c7cfb3f.webp?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Model airplane puzzle kit with engraved details
Instruction
Information
An airplane puzzle model with engraved details and spinning propeller.
Instruction
Step1: Cut out the pieces
Cut out the pieces. Some pieces are quite delicate so make sure you handle them carefully.
Step2: Add the wing and motor to the center body
Glue the wing and the motor parts to the center body part. Make sure everything is aligned.
Step3: Add middle body side panels
Add the middle body side panels to each side. There are no notched features so make sure you place the symmetrically. They should contact the wing on the bottom. You can use clamps to keep them in place while the glue dries.
Step4: Add the back wing and assemble the tank
While you wait for the glue to dry from the previous step, you can add the back wing (horizontal stabilizer) and assemble the tank part.
Step5: Add external body side panels
Glue on the external body side panels. There are no notched features so just position them as you see fit but the same on both sides. You can again use clamps to keep the panels in place while the glue dries.
Step6: Add the wheels and the tank
Glue on the wheels and the tank on the bottom side of the airplane.
Step7: Add the propeller
Slide on the propeller on to the shaft. Do not glue it. The propeller should turn. If it doesn't you can sand the propeller internal hole s bit until it fits.
Add the end cap. Make sure you don't glue the propeller as well. I fount it the easiest to add glue only from the front side, which should keep it in place.
