Report
![[Laser cut and engrave] Simple Easter Ornament for Beginners](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/11666518-854d-4c36-ba86-8adb163d813f?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Simple Easter Ornament for Beginners
Remix
Instruction2024easter
.xcs
Application scenario
Laser (5min)
Machine & module
xTool P2
Material used
Basswood Plywood
71
948
Information
I saw this project shared by @metoudesign on the home page recommendation and thought this is really cute and easy to make. It only took me less than 5 mins to make it.
This remix is based on
Easter Ornament
metoudesignInstruction
1
Step1: Cut the ornament shape
Preview
Preview
Cut the ornmanet using your machines. The new “easyset” function of XCS 2.0 allows you to choose the ideal effect based on your machines, so you don't have to use a P2 to make this project. Just use your machine and adjust the settings using the “easyset” function.
2
Step2: Cut the middle layer using a colored paper
Preview
I just used the bottom part to make a outline on a wrapping paper, then cut it out.
Tip: I think it would be better to cut within the outline because when I glue them I found the middle layer is a bit bigger than I expected.
3
Step3: Glue the layers together
Preview
This is probably the most important part
Tip: Remember to glue the mirror opposite side cause I got it wrong the first time so I wash the glue off and did it again
4
Step4: Final result
Preview
Simple and cute
Comments
