Report
![[Laser cut and engrave] Stainless steel flask](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/68c371e6-2189-43bb-9816-0be07f83f12a?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Stainless steel flask
Instruction20240310_113312
.jpg
Application scenario
Laser (15min)
Machine & module
xTool M1
10WMaterial used
Gold Laser Foil with Plywood
Aluminum Business Cards (300pcs)
Stainless Steel
59
940
Information
Just trying to get the hang of it all. Figured I would try a detailed image and see what I get. I had some failed attempts but once I got the auto measure figured out it was fine.
Instruction
1
Step1: Wash flask with alcohol to clean. Then fill with cold water I did this so the metal didn't get hot.
Clean with alcohol and fill with cold water to keep the flask cool
2
Step2: Place flask in machine and auto measure on the lowest part of where you plan on putting your image.
Place in machine and auto measure the lowest area you plan to engrave.
3
Step3: Use metal card setting or just 90 power 250 speed 1 pass
Run metal business card or the setting provided
4
Step4: Clean flask with rubbing alcohol and magic eraser to get it clean. Then a good soap and water clean just to be safe. ENJOY!
Clean flask again to get access off. Iused a magic eraser and alcoho followed with dawn and hot soap to be safe.
Comments
