Scorch&Sage
Report

Laser Cut Wooden Apple Earrings with Metal Hooks

Instruction
Apple.xcs
Apple
.xcs
Application scenario
Laser processing
Machine & module
xTool F1 Ultra
20W
Material used
1.5 mm basswood
23
153

Information

      Created for the back-to-school challenge! I hope you all enjoy and thank you for the support! and please feel free to look through any of my other designs every download helps so!
    

Instruction

1

Step1: Place Design

Laser Cut Wooden Apple Earrings with Metal Hooks instruction: step 1 - Place Design
Preview

Place your design where you'd like it to be, if doing multiple make sure you rotate, flip, etc save that material!

2

Step2: Settings

Laser Cut Wooden Apple Earrings with Metal Hooks instruction: step 2 - Settings
Preview

Always double check your settings it is a miserable thing to go through all the work and forget to turn the power up from the default 1% would hate for you to waste material!

3

Step3: Ensure Send off

Laser Cut Wooden Apple Earrings with Metal Hooks instruction: step 3 - Ensure Send off
Preview

Make sure the design is sent, when you get there make sure your guard is down! When your safety check is complete press your Xtool button on the command pad. I always forget this step haha

4

Step4: Lift away

Laser Cut Wooden Apple Earrings with Metal Hooks instruction: step 4 - Lift away
Preview

It should just lift away when you pull up the board if it doesn't, try adding a pass to your times! or you can try reprocessing but you may burn the bottom of your machine

5

Step5: Finish up

Laser Cut Wooden Apple Earrings with Metal Hooks instruction: step 5 - Finish up
Preview
Laser Cut Wooden Apple Earrings with Metal Hooks instruction: step 5 - Finish up
Preview

These ones don't necessarily need stain, but you can always make that call! A good dark stain might look good on these

Comments

Remixes

xTool Supplies Used in This Template

xTool F1 Ultra
xTool F1 Ultra