Report
Laser Cut Wooden Backpack Earrings with Hooks
InstructionBackpackEarrings
.xcs
Application scenario
Laser processing
Machine & module
xTool F1 Ultra
20WMaterial used
1.5 MM Basswood
12
Information
Created for the back-to-school challenge! I hope you all enjoy and thank you for the support!
Instruction
1
Step1: Place Design
Preview
Place your design where you'd like it to be, if doing multiple make sure you rotate, flip, etc save that material!
2
Step2: Settings
Preview
Always double check your settings it is a miserable thing to go through all the work and forget to turn the power up from the default 1% there are 3 settings in here dont mix them up and waste
3
Step3: Ensure Send off
Preview
Make sure the design is sent, when you get there make sure your guard is down! When your safety check is complete press your Xtool button on the command pad.
4
Step4: Lift away
Preview
It should just lift away when you pull up the board if it doesn't, try adding a pass to your times!
5
Step5: Finish up
Preview
Preview
These ones don't necessarily need stain, but you can always make that call!
Comments
