Laser Cut Wooden Game Controller Money Holder
Instruction
Information
This money holder is a real eye-catcher.
Whether as a special gift for gamers, a stylish accessory, or simply a creative way to present money, this card allows you to give your gift in an original and unique way.
The size of the controller is exactly the same as the original.
Instruction
Step1
The controller is made up of 16 parts that need to be glued together with either superglue or wood glue. Take care with the small parts, as they can easily fall through the honeycomb.
It is best to use tweezers for all parts.
Step2
There are lines on the controller to help you stick all the pieces in the right place.
A little tip:
To avoid getting too much superglue or wood glue on the small parts, you can simply use a small toothpick.3
Step3
Glue all the pieces to their designated places. It doesn't matter where you start. Just make sure you glue carefully and take your time.
Once you have glued all the parts together and they have dried, you can now choose the position of the joysticks. Either in the center or in a position of your choice.
Step4
Screw rivets can be used to fasten the two halves together. The length of the rivets should be 6 mm for 3 mm plywood.
Alternatively you can use pattern bag clips or a nice cord.
