TIE Advanced X1
The Creator Spark Challenge
Instruction
Information
A TIE Advanced X1 fighter from starwars.
Quite easy and quick to assemble and doesn't require a lot of material area.
Instruction
Step1: Laser cut the parts
Laser cut all of the parts.
Step2: Assemble the main body
Assemble the middle of the body and cabin. The first picture shows how all of the pieces go together in order. Note where the smallest circular piece and hexagonal piece are.
Join all the pieces together.
Step3: Assemble the rest of the body and middle wings
Add the body and the back piece to the middle wings as shown in the picture.
First install one wing and then the other. Make sure that everything is properly aligned an parallel.
Step4: Assemble the top and bottom wing parts
Assemble the top and bottom wings as in the pictures. The wings are all the same so you can't mix them up.
Make sure the wings are aligned and parallel. Quickly continue to the next step before the glue sets, so you still have time to make adjustments.
Step5: Add the top and bottom wings to the body
Add the top and bottom wing assemblies to the body. It doesn't matter which one is on top and which one on bottom.
The center pieces slide between the two larger circular pieces of the body, where the free holes are.
Make sure everything is aligned and parallel.
