Wooden shell-shaped napkin holder with engraved shell.

Place the basswood on the baseplate (if you use other materials please update the settings to match).

Measure the focal point - ruler.  Then set the processing size available (will need the 12 by 12 size).  Make sure the pieces fit (or break them up on different runs).

The settings are standard.  Used a higher power for the engraving (usually defaults at 20 but increased it to 26).  Also increased the number of lines to 120.

Check the framing and then process.

Place glue on the edges and glue together.  Let it dry.  Make sure that you prop it to ensure that it dries straight.  

Enjoy!