HomeTemplatesDecorHome DecorDoor Sign
Gena
Report
[Laser cut and engrave] Hope You Like Dogs
Project made with xTool P2 machine for Laser cut and engrave.
[Laser cut and engrave] Hope You Like Dogs
[Laser cut and engrave] Hope You Like Dogs

Hope You Like Dogs

Instruction
Welcome I hope you like dogs V1.xcs
Welcome I hope you like dogs V1
.xcs
Application scenario
Laser (60min)
Machine & module
xTool P2
55W
Compatibles · 8
Material used
Birch Plywood
1/8"(3mm) MDF Board
192
1490

Information

      I made a door hanger for a craft show and everyone loves dogs! Those little symbols in the "O" are paw prints but they do not show up well the picture but they do in person.

Instruction

1

Step1: Make Cuts on Laser

Hope You Like Dogs instruction: step 1 - Make Cuts on Laser
Preview
Hope You Like Dogs instruction: step 1 - Make Cuts on Laser
Preview
Hope You Like Dogs instruction: step 1 - Make Cuts on Laser
Preview
Hope You Like Dogs instruction: step 1 - Make Cuts on Laser
Preview

I used 3 pieces of 12 X 24 inch birch plywood pieces so they would size correctly for the 18" mdf circle. Total cut time was less than 20 minutes.

2

Step2: Paint the Pieces and Glue together

Hope You Like Dogs instruction: step 2 - Paint the Pieces and Glue together
Preview

I used three colors for this project. (Brown, Ivory and Black).

3

Step3: Add a Clear topcoat if it will be outside

Forgot to take a picture of this step.

4

Step4: Add a bow or rope for hanging

I added a bow to this project. I source my ribbon from Hobby Lobby and Amazon. A hemp cord would also work.

Comments

Remixes

xTool Supplies Used in This Template

xTool P2
xTool P2
1/8"(3mm) MDF Board
1/8"(3mm) MDF Board

License

CC0