HomeTemplatesFashion & WearablesAccessories
svilla
Report
[Laser cut and engrave] Laser Cut Wooden Flip Flop Earrings Handmade Accessories
Project made with xTool P2S,xTool F1 Ultra,xTool M1 Ultra,xTool F1 machine for Laser cut and engrave.

Flip Flop Earrings ( with a twist

Remix
Instruction
SandalEar.xcs
SandalEar
.xcs
Application scenario
Laser processing (2min)
Machine & module
xTool P2S
55W
xTool F1 Ultra
20W
xTool M1 Ultra
10W, 20W
xTool F1
10W
Compatibles · 7
Material used
1/8" Walnut Plywood
2
16

Information

      I found this pattern on Atomm and add a small twist that you cut an extra set of straps. This will give it a 3D feel on either side of the earring.

This remix is based on

atomm-remix-cover
Laser Cut Wooden Flip Flop Earrings Handcrafted Accessories
Scorch&Sage

Instruction

1

Step1: Load the file into XCS and prepare for cutting.

Flip Flop Earrings ( with a twist instruction: step 1 - Load the file into XCS and prepare for cutting.
Preview

Load the file into XCS and make sure that the settings are correct for your machine and wood. 

2

Step2: Glue up pairs of straps

Take the two of the strap pieces and glue them together. Do the same thing for the other two strap pieces.

3

Step3: Glue Strap back into Flip Flop

Flip Flop Earrings ( with a twist instruction: step 3 - Glue Strap back into Flip Flop
Preview

Glue the straps back into the flip flop so a little bit hangs out either side. This gives a little dimension to the project.

4

Step4: Put on Hardware and enjoy!

Flip Flop Earrings ( with a twist instruction: step 4 - Put on Hardware and enjoy!
Preview

Put on your preferred earring hardware and wear to the beach

Comments

Remixes

xTool Supplies Used in This Template

xTool P2S
xTool P2S
xTool F1 Ultra
xTool F1 Ultra
xTool M1 Ultra
xTool M1 Ultra
xTool F1
xTool F1
1/8" Walnut Plywood
1/8" Walnut Plywood

License

CC BY-SA