Youth Beanies

Instruction

YouthBeaniePatches

.xcs

Application scenario

Laser processing

Machine & module

xTool S1

40W

Material used

Amazon Purchased Leather Patches

162

Information

      Youth Beanie Patch images that were good sellers in my area. 
*REMEMBER settings could all vary between every machine, it's best you get test grids done on yours to ensure the proper setting

beanies

leather

Instruction

Step1

Preview

The patches were purchased off of Amazon. I ran a test grid for each color and I found (for my machine) the 40% power and 400 speed worked on all patches.
Almost every design option is an “image” and not a vector, but they worked just as well!

After placing patches in machine, be sure to run a measure test (I use the Auto-Measure option)
Next, mark your processing area (please make sure to process INSIDE the stitching line. This will help make sure the stitching design stays intact and doesn't run in with the image)
Set the image inside your processing marks (stretch and adjust image(s) as needed)
Make sure the power and speed are set up (it might vary a little differently than my setting, but I still left my setting info in the xcs file)
Finally, close the lid and process

These do have their own adhesives on the back of the patches, but I have come to find that they come off after awhile. So, I use a little bit of super glue on the back of the patch before applying them onto the beanies.

Comments