Slate (rock) Coaster:

1. Do a measure test onto one of the coasters (I use the auto-measure setting)
2. Mark your coasters' processing area (I can squeeze 2 ½ sets in my processing area).
   Once it's marked, place an image in that box and size it to whatever you want (I leave a little space when using rock coasters to keep the image clean)
3. After you get images placed where you want them to be, then close your lid to the machine and process it.
4. The power and speed is in the xcs file

Box:
*I stain my wood before processing and give about a day to dry before placing in machine. You don't have to do this, but it's what I do

1. Place your sheet of wood in the machine and do a measure test (I use the auto-measuring setting)
2. Mark your wood processing area (this takes up as much space as the xtool allows, so be cautious)
3. I can fit all the pieces to cut onto a single sheet (I left the wood exactly how I run it on the sheet in the xcs file) but if you need to, please arrange it to your liking
4. Once you have the box pieces fitted inside your processing area (the setting I use is also in the xcs file) go ahead and close the lid and process it. 
5. Once everything is all cut out you will need to glue the pieces together. It's a slider box, so make sure that you are gluing everything tight to ensure it'll be a functioning slider box.