Scorch&Sage
Report

Laser Cut Wooden Floral hibiscus Drop Earrings

Instruction
Earhibiscus.xcs
Earhibiscus
.xcs
Application scenario
Laser processing
Machine & module
xTool F1 Ultra
20W
Material used
1.5 MM Basswood plywood
1
5
Information
      To celebrate becoming a premium creator I'm releasing some more free designs! I hope you all enjoy and thank you for the support!
    
Instruction
1
Step1: Place Design
Preview

Place your design where you'd like it to be, if doing multiple make sure you rotate, flip, etc save that material!

2
Step2: Settings
Preview

Always double check your settings it is a miserable thing to go through all the work and forget to turn the power up from the default 1%

3
Step3: Ensure Send off
Preview

Make sure the design is sent, when you get there make sure your guard is down! When your safety check is complete press your Xtool button on the command pad.

4
Step4: Lift away
Preview

It should just lift away when you pull up the board if it doesn't, try adding a pass to your times!

5
Step5: Finish up
Preview

I usually finish up with a stain but these do work right out of the machine so it is up to you! good luck out there and stay safe!

Comments
Remixes
xTool Supplies Used in This Template
xTool F1 Ultra
xTool F1 Ultra