Laser Cut Wooden Cherry Earrings Handcrafted Lightweight Jewelry

Place your design where you'd like it to be, if doing multiple make sure you rotate, flip, etc save that material!

Always double check your settings it is a miserable thing to go through all the work and forget to turn the power up from the default 1%

Make sure the design is sent, when you get there make sure your guard is down! When your safety check is complete press your Xtool button on the command pad.

It should just lift away when you pull up the board if it doesn't, try adding a pass to your times!

I usually finish up with a stain but these do work right out of the machine so it is up to you! good luck out there and stay safe!