aidenm
Report

Baby's First Christmas Ornament with Custom Photo

Instruction
Baby'sfirstChristmasornamentround.xcs
Baby'sfirstChristmasornamentround
.xcs
Application scenario
Laser processing
Machine & module
xTool D1 Pro
20W
Material used
3mm Basswood Plywood
Photo
Ribbon
4
Information
      This Christmas ornament is to help remember a baby's First Christmas.
    
Instruction
1
Step1: Cut out your photo
Preview

Cut out a photo in a 45mmx45mm square. I cut this out of a wallet sized photo graph. Make sure that the face will show in the opening in the front of the ornament.

2
Step2: Add the photo to the ornament
Preview

Now place the photo in the engraved square.

3
Step3: Glue the ornament together
Preview
Preview

Now add glue to the part of the ornament that has the photo in it, as shown in the first photograph, then place the front of the ornament onto the part with the picture in it. I used a jig that I made, but you can line up both parts by hand.

4
Step4: Add a hanger
Preview
Preview
Preview
Preview

Now you will need to add a hanger for the ornament. I used a piece of 1/8in(3mm) wide red ribbon. I cut a piece about 10inches(254mm) long and then tied it into a loop as shown in the first picture. I then threaded one end of the loop through the hole in the top of the ornament. I then brought the end of the loop through the other end of the loop as shown in picture three. Then I pulled the hanger tight by pulling on the end that I had threaded through the hole in the top of the ornament.    

5
Step5: Finished
Preview

Your ornament is now finished!

Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro
3mm Basswood Plywood
3mm Basswood Plywood