HomeTemplatesDecorHome DecorShelves & Holders
girhiny.eszter
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Personalised Dog Photo Frame with pet portrait graphic

Cherished Moments Craft ChallengeAtomm Featured
Instruction
dogphotoframe.xcs
dogphotoframe
.xcs
Application scenario
Laser processing (30min)
Machine & module
xTool S1
10W
Compatibles · 10
Material used
3mm Basswood Plywood
16
Information
      A dear friend of mine asked me to make a picture frame of the dog, featuring the dog in the picture with her graphic likeness.
Instruction
1
Step1: Design
Preview

I made the graphic based on the picture, then the silhouette from it. I wrote the dog's name (Folti), and added it to the graphic. I've made many photo frames before, so I had a basis for it. I just had to place the graphic on top of the picture frame.

2
Step2: Cut
Preview

I set up the machine and cut out all the pieces. (I accidentally started painting here when I realized I should take photos.)

3
Step3: Paint
Preview

I painted the top layer of the dog and its name, and the bone and paws.

4
Step4: Assamble
Preview
Preview
Preview

I glued the painted layer to the frame, while the frame and backrest needed to hold the picture went on the back. I also glued the support for the photo holder together as shown in the picture, then it went on the back.

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1
3mm Basswood Plywood
3mm Basswood Plywood

License

CC BY-NC-ND
This work contains AI-generated content.