Report
Laser Cut and Weld Modern Coffee Table with Monstera Leaves Design
InstructionCoffeeTable
.xcs
Application scenario
Laser welding / cleaning、Laser processing (45min)
Machine & module
xTool MetalFab Laser Welder
1200WAccessories
xTool MetalFab CNC Cutter
Material used
3mm Stainless Steel
3mm 304 Stainless Stee
5
90
Instruction
1
Step1: Connect the machine, place the material
Preview
Preview
- Open and connect the welding machine to the cutting platform, then plug on, turn on the gas(nitrogen cylinder of 174 PSI/1.2 MPa or set the xTool air compressor with dryer at the highest pressure of 145 PSI/1.0MPa while xcs will show 0.5-0.7MPa when processing).
- Place a 24''x 24''(610 x 610 mm) sheet on the cutting platform and secure it with the blade and slats.
2
Step2: Insert the XCS file
Preview
Turn on the machine, open xTool Creative Space on the computer, drag in the required xcs file, and adjust the parameters according to your materials.
3
Step3: Calibrate the capacitive sensor, Framing and Processing
- Click the start calibration button and then click on the center area of the material image to perform calibration.
- Click the "Framing" to confirm that it is within the processing range. If there are no issues, close the lid, click "Process" and press the "Start" button of the cutting platform.
- Follow the steps above to replace the material and cut out all the patterns
4
Step4: Equipment Switching
Preview
Preview
Preview
Preview
- Reduce the pressure of the nitrogen cylinder to 14.5-29 PSI(0.1-0.2 MPa). (If you used a compressor and dryer, disconnect from the welding machine and connect the nitrogen cylinder.)
- Disconnect the wiring between the welding machine and the cutting platform, and connect the wire feeder to the welding machine.
- Remove the capacitor head from the welding gun and install the welding head and wire feeding tube.
- Install the welding wire and Connect the workpiece sensing cable onto the metal part that needs to be welded to complete the circuit.
5
Step5: Assembly and Welding
Preview
Choose the material 1/8'' (3mm) Stainless Steel to apply the built-in welding parameters, and proceed with welding (Remind to enable wire feeding and lasering)
Comments
Remixes
xTool Supplies Used in This Template