Laser Cut Wooden Wheelbarrow Birthday Gift Decoration
Instruction
Information
For a garden party or the garden enthusiast's birthday. A special gift basket. Decorated with a potted flower or a suitable gift.
I've spent a long time trying to find the settings that reduce root marks the most. Unfortunately, I haven't quite succeeded yet. If anyone can help with this, I'd be very grateful for any feedback.
Instruction
Step1: The Start
Thank you in advance for your interest and for downloading my file.
As always, we'll start with cutting and engraving.
To ensure strength, please use wood glue.
We'll start with the base plate and the handle or substructure.
Step2: Side panels
Next are the two side panels.
Step3: Front/Back
The front and back.
Please note: the holes in the base plate are intentionally slightly offset from the center. The front and back panels only fit in one direction. The openings are also slightly wider to allow for optionally attaching the sides at an angle.
Step4: Stand Elements
The stand elements.
Step5: Wheel
The wheel.
We'll take both tire sections and glue them together, overlapping each other.
Step6: Install the wheel
Please attach the wheel as follows:
Push the two inner circles (glued together) back into the wheels, then position and glue the larger circles to the right and left of them. Push the fixing rod through the holes in the wheelbarrow as shown in the pictures. Seal the outer ends with the small circles and glue them.
Step7: The Result
Done!
