HomeTemplatesDecorGardening & Outdoor Decor
Gena
Report
Laser cut and engrave Laser Cut Yellow Acrylic Bee Wind Spinner Decor
Project made with xTool P2 machine for Laser cut and engrave.
Laser cut and engrave Laser Cut Yellow Acrylic Bee Wind Spinner Decor
Laser cut and engrave Laser Cut Yellow Acrylic Bee Wind Spinner Decor
Laser cut and engrave Laser Cut Yellow Acrylic Bee Wind Spinner Decor

Wind Spinner with Bee

Instruction
WindSpinnerBee.xcs
WindSpinnerBee
.xcs
Application scenario
Laser processing (15min)
Machine & module
xTool P2
55W
Material used
3mm Yellow Sparkle Acrylic
6
75
Information
      I created a wind spinner to hang on the back patio. This was a quick project that took less than 15 minutes to cut, shape and hang. The acrylic was sourced from XTool.
Instruction
1
Step1: Cut Acrylic
Preview

Cut settings were power 60 and speed 15. Cut time was about 7 minutes.

2
Step2: Use Heat Cut to Bend/Shape
Preview

I heated the two vertical spines in the middle for about 60 seconds and then used my hands to bend to the desired shape. I blew on the heated sections for a minute or so until the acrylic hardened.

I used a small piece of fishing line to hang.

Comments
Remixes
xTool Supplies Used in This Template
xTool P2
xTool P2

License

CC BY