![[Laser cut and engrave] Acrylic desk organizer @5weeks5projects (4)](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/a4779348-47ce-4698-924f-01feb5438c42?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Acrylic desk organizer @5weeks5projects (4)
Instruction
Information
Acrylic desk organizer from red and clear acrylic, with 3 compartments.
Instruction
Step1: The back side
Insert the image and click outline and set it to zero.
Move the image a side or delete it, since it's no longer needed.
Step2: The bottom
Insert a square and unlock the size lock.
Place it under the outer line image and size it to the same width as the outer line image.
You can make the height as big or small as you want, but i made it about half the size of the outer line image.
Lock the size.
Step3: The sides
Insert a square and unlock the size. Make the height a bit smaller and the height the same size as the bigger rectangle.
Lock the size
Step4: Inner walls
Copy and paste the side piece 3 times, so you have 4 pieces.
Insert another square and unlock the size and make it rectangle.
The size should start the same as the bottom piece, but then adjust the height to the height as the side piece.
Step5: Cutting and asembling
Once all the pieces are cut out, you can start gluing them.
I started gluing the bottom piece and the front piece, then the middle pieces and then the side pieces. The back piece, i glued in last.
The desk organizer is now ready to be used.
