Father's Day Wooden Motorcycle Ornament
Instruction
Information
A small token of appreciation for my father in law who is an avid biker. Kept it fairly simple due to his tastes, but could personalize.
Instruction
Step1: Set Up File
Open the file and check the cut settings for your machine.
Optionally, I highlighted areas in my screenshot above for potential areas to customize this gift: Write a message, list your siblings, whatever you think your father figure will prefer.
You could also size up or down all pieces consistently to make a keychain or plaque, though be aware that making them smaller will likely cause some breakage, especially in the trees.
Step2: Cut Layers
Cut out the layers with your machine, always keeping safety in mind.
Step3: Glue Layers
Glue the pieces one layer at a time to ensure alignment.
Glue the mountain layer on top of the base and weigh it down to set.
Next, glue the biker and tree on top of that and weigh it to set.
Finally, glue the frame layer on top an weigh to set. Add a string to hang.
