HomeTemplatesTools & Special MaterialsJigs
wetherbeemike62
Report
Laser cut and engrave
Project made with xTool F1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave

Business card jig for the F1 slide extension

Instruction
Business Card template blank.xcs
Business Card template blank
.xcs
Application scenario
Laser (60min)
Machine & module
xTool F1
Compatibles · 8
Material used
Birch Plywood
606
3856
Information
      This template holds 6 business cards.  I made holes in the bottom board for easy out removal.  The bottom board and the top board are the same size.
Instruction
1
Step1: cut the bottom board my dimensions are slightly smaller than the extension and you should cut the red holes and the outer perimeter for the first cut

Make sure when cutting with the f1 that you stay off the edge of the wood or you will get a fire and the machine will shut down 

2
Step2: Cut the top board you should cut the outer perimeter and the inner squares and ignore the holes on this cut

This board makes batching business cards for the f1 a breeze I just finished 50 for a customer today!!!!

3
Step3: After cutting out both boards glue them together making sure they are exactly aligned to one another

make sure to remove any glue inside your card holes while it is soft as that is when it is the easiest.  I used a pocket knife with a pointed blade to remove small bits of glue.

Comments
Remixes
xTool Supplies Used in This Template
xTool F1
xTool F1