Report
Mama Bear Mother's Day Ornament
InstructionMother'sDayMamaBear
.xcs
Application scenario
Laser processing
Machine & module
xTool D1 Pro
10WCompatibles · 10
Material used
1/3"(8mm) Basswood Plywood
28
343
Information
Ornament made for my mother-in-law who is a mama bear ready to protect her children even though they are fully adults.
Instruction
1
Step1: File Setup
Preview
eview layers and confirm everything looks good.
If you want to customize or change the message:
- copy everything, layer in the correct order, and change to engrave (This will allow you to see the position of the message)
- Adjust wording of engraved message
- Delete the top layers, besides the text and bottom “whole” layer
- Copy these two layers to replace the original. Make sure the layers are returned to cut for the “whole” layer and engrave for the message.
2
Step2: Cut Out Layers
Cut out the layers with your machine.
3
Step3: Glue Ornament together
Preview
Preview
Preview
Glue the 2nd layer (bear) on top of bottom layer (text), clamp or use something heavy to keep them together until it sets. Add the third layer (flowers) and clamp/set. Finally, add the final layer and clamp/set. Add a string if you want to hang the ornament.
Comments
