HomeTemplatesDecorKitchen Decor
genesisacsabi
Report
Laser cut and engrave
Project made with xTool S1 machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave

Red Robin tumblers

Instruction
PXL_20240124_210426846.jpg
PXL_20240124_210426846
.jpg
Application scenario
Laser (12min)
Machine & module
xTool S1
20W
Material used
Stainless Steel
33
940
Information
      A friend of mine asked me to make a few personalized tumblers for Red Robin restaurant, a location close to me. I made a few with two different styles of stainless steel tumblers and, honestly, they look great.
Instruction
1
Step1: Create the logo file
Preview

Notice: this is a copyrighted logo so please don't use commercially. I got permission to use it because it was for the use of employees of such restaurant.

I got the design and using the XCS tools I got a pretty good outline of the logo

2
Step2: Set the tumbler on the RA2
Preview

Position the tumbler on the RA2 

3
Step3: Set the area where the engraving would be.
Preview
Preview

Using the XCS set the area of the tumbler to be engraved.

4
Step4: Set the S1 to engrave tumblers
Preview

Select the appropriate material, configuration and power to engrave. In this case I used cylindrical object, stainless steel and 70% power, 140 mm speed.

5
Step5: Preview engraving area
Preview

This step is just to make sure you've selected the desired area to engrave. Use the XCS to set this area properly.

6
Step6: Just do it
Preview

After the engraving is done, clean the tumbler properly and show it off to the world.

I'm sure you can create wonderful projects.

Comments
Remixes
xTool Supplies Used in This Template
xTool S1
xTool S1