HomeTemplatesTools & Special MaterialsTest Grid
Robs Creation Lab
Report
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick
Project made with xTool F1 Ultra machine for Laser cut and engrave.
Project made with xTool F1 Ultra machine for Laser cut and engrave.
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick
Project made with xTool F1 Ultra machine for Laser cut and engrave.
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick
Project made with xTool F1 Ultra machine for Laser cut and engrave.
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick
[Laser cut and engrave] Anodized Aluminum Business Card - Red and Black 0.8mm Thick

Anodized Aluminum Business Card - Red and Black 0.8mm Thick

Instruction
ThickAluminumBusinessCardHIGHPOWERTesterx2.xcs
ThickAluminumBusinessCardHIGHPOWERTesterx2
.xcs
Application scenario
Laser processing
Machine & module
xTool F1 Ultra
20W
Compatibles · 11
Material used
1/25"(1mm) Black Anodized Aluminum
67
562

Information

      Simple test for Fiber Laser testing. There is a High-Power test and a Low-Power file. The file was run on Red and Black

Instruction

1

Step1

First you will need to find the 0.8mm Anodized Aluminum Business Cards on Amazon, or other location

2

Step2

Place 0.8mm Anodized Aluminum Business Card on work surface

3

Step3

Using framing, or your method, line up the Anodized Aluminum Business Card with the Red and/or Black

4

Step4

Select the group you will NOT BE USING, and turn the output off. Make sure the group you are using is on

5

Step5

Close Protective Cover and run the file

6

Step6

*Caution: The Material May Be Hot*  Once complete, remove the test material and inspect it. If done, great job and enjoy. 

If you are continuing, flip the Business Card over and return to step 3, and continue the test

Comments

Remixes

xTool Supplies Used in This Template

xTool F1 Ultra
xTool F1 Ultra
1/25"(1mm) Black Anodized Aluminum
1/25"(1mm) Black Anodized Aluminum

License

CC0