HomeTemplatesDecorSeasonal & Themes DecorSeasonal Decor
MissFortune
Report
[Laser cut and engrave] Fall Gnome
Project made with xTool M1 machine for Laser cut and engrave.
Project made with xTool M1 machine for Laser cut and engrave.
[Laser cut and engrave] Fall Gnome
[Laser cut and engrave] Fall Gnome
[Laser cut and engrave] Fall Gnome
[Laser cut and engrave] Fall Gnome

Fall Gnome

Application scenario
Laser (90min)
Machine & module
xTool M1
Material used
1/8"(3mm) Basswood Plywood
2054

Information

      I engraved the back of the board with a fall pattern of acorns and leaves. I then stained the board instead of painting so the engraving would show through. I got glued florals onto the back. I cut out a small paper rose pattern and rolled it and super glued it to his hat.
Comments

Remixes

xTool Supplies Used in This Template

xTool M1
xTool M1
1/8"(3mm) Basswood Plywood
1/8"(3mm) Basswood Plywood