HomeTemplatesTools & Special MaterialsJigs
Tech Craftsmen
Report
[Laser cut and engrave] Koozie Jig
Project made with xTool S1 machine for Laser cut and engrave.

Koozie Jig

Instruction
Kooziejig.xcs
Kooziejig
.xcs
Application scenario
Laser processing
Machine & module
xTool S1
20W
Compatibles · 11
Material used
1/4"(6mm) Walnut Plywood
39
424

Information

      This jig was made for batch orders of koozies.

Instruction

1

Step1

Koozie Jig instruction: step 1 -
Preview
Koozie Jig instruction: step 1 -
Preview
Koozie Jig instruction: step 1 -
Preview

Place your 12x24 in. panel in the S1, make sure the right side is snug against the wall while being carful not to have it on top of the lip, line up corners shown with the black screws. I lined it up with the side of the screw closest to me when S1 was open.

2

Step2

Go to XCS. Frame to make sure its in your area that you want it. Then process.

3

Step3

Once complete make note where you lined up your corners if you didn't follow the 1st step or had to move the panel for some reason.

4

Step4

Now you can use the jig! Back on the XCS go to your laser settings and change the output to off. Select all items and lock into place. The shapes are color coded and can be used to get a rough estimate of work area on the Koozie. 

5

Step5

Koozie Jig instruction: step 5 -
Preview

And finally Enjoy!

Comments

Remixes

xTool Supplies Used in This Template

xTool S1
xTool S1
1/4"(6mm) Walnut Plywood
1/4"(6mm) Walnut Plywood

License

Standard License