HomeTemplatesDecorHome DecorWall Art
Bouncer
Report
[Laser cut and engrave] THE FAB FOUR
Project made with xTool P2,xTool D1 machine for Laser cut and engrave.
Project made with xTool P2,xTool D1 machine for Laser cut and engrave.
[Laser cut and engrave] THE FAB FOUR
Project made with xTool P2,xTool D1 machine for Laser cut and engrave.
[Laser cut and engrave] THE FAB FOUR
[Laser cut and engrave] THE FAB FOUR
[Laser cut and engrave] THE FAB FOUR
[Laser cut and engrave] THE FAB FOUR
[Laser cut and engrave] THE FAB FOUR

THE FAB FOUR

Instruction
Beatles.xcs
Beatles
.xcs
Application scenario
Laser processing (20min)
Machine & module
xTool P2
55W
xTool D1
10W
Material used
3mm white mdf
3mm acrylic
1/8"(3mm) MDF Board
1/8"(3mm) Black MDF Board
135
672

Information

      Here's a fun project for those that like The Beatles. 
The illustrations are for 2 layers on a guitar stand but I have included templates for a single layer stand and the option to remove the stand and just have a backing.
The 2 layer option can be viewed from either side.

Instruction

1

Step1: Cut out the pieces

THE FAB FOUR instruction: step 1 - Cut out the pieces
Preview

Select one of the options

Cut out the pieces and glue them together.

My base pieces were of a tight fit and didn't require any glue.

Don't forget to change the base slots to suit your laser and materials. (Kerf)

Use masking tape on your material to get a clean finish.

Comments

Remixes

xTool Supplies Used in This Template

xTool P2
xTool P2
xTool D1
xTool D1
1/8"(3mm) MDF Board
1/8"(3mm) MDF Board
1/8"(3mm) Black MDF Board
1/8"(3mm) Black MDF Board

License

CC BY-NC-SA