Report
Brass Chandelier
Instruction0
.5mmBrassChandelier-OrdinaryNozzle-1
Show 1 more
Application scenario
Laser welding / cleaning
Machine & module
xTool MetalFab Laser Welder
1200WAccessories
xTool Selected Air Compressor
xTool Selected Ary Dryer
Material used
1/50''×24''×24''(0.5mm×610×610) Brass* 4pcs
109
1171
Information
Create a stunning brass chandelier using the xTool MetalFab! This easy DIY project not only provides beautiful lighting but also serves as a decorative statement piece. Imagine the charm it will bring to your space—and you can even sell it for profit! Showcase your creativity and craftsmanship. Start your chandelier project today and light up your home!
Instruction
1
Step1: Connect the machine, place the material
Preview
Preview
- Connect the CNC cutting platform and laser welder
Open and connect the welding machine to the cutting platform, then plug on, turn on the gas(nitrogen cylinder of 174 PSI/1.2 MPa shown in XCS or set the xTool air compressor with dryer at the highest pressure of 145 PSI/1.0MPa while XCS will show 0.5-0.7MPa when processing). - Place the material
Place a 24''x 24''(610 x 610 mm) sheet on the cutting platform and secure it with the blade and clamps.
2
Step2: Insert the XCS file
Preview
Preview
Turn on the machine, open xTool Creative Space on the computer, drag in the required xcs file, and adjust the parameters.
3
Step3: Calibrate the capacitive sensor
Preview
Click the start calibration button and then click on the center area of the material image to perform calibration.
4
Step4: Framing and Processing
- Click the "Framing" to confirm that it is within the processing range. If there are no issues, close the lid, click "Process" and press the "Start" button of the cutting platform.
- Follow the steps above to replace the material and cut out all the patterns
5
Step5: Equipment Switching
Preview
Preview
Preview
Preview
- Adjust the gas pressure
Reduce the pressure of the nitrogen cylinder to 14.5-29 PSI(0.1-0.2 MPa). (If you used a compressor and dryer, disconnect from the welding machine and connect the nitrogen cylinder.) - Cable connection for welding
Disconnect the wiring between the welding machine and the cutting platform - Assemble the wire-free welding nozzle
Remove the capacitor head from the welding gun and install the wire-free welding nozzle. - Connect the workpiece sensing cable
Install the welding wire and Connect the workpiece sensing cable onto the metal part that needs to be welded to complete the circuit.
6
Step6: Assembly and Welding
Preview
- Assemble the main part
Use masking tape to assemble the main unit for easier welding - Pause welding first
Choose the material ＜1/25'' (1mm) Brass to apply the built-in welding parameters, and proceed with welding (Must use the wire-free welding nozzle and enable lasering) - Continuous welding
Pause welding at key points first and then use continuous welding for stronger connection
7
Step7: Install the bulb and connect the power wires
Please pay attention to safety!
8
Step8: Must-know Suggestions
- The welding machine cannot be connected to the cutting platform and wire feeder simultaneously; you need to switch device connections and adjust the gas pressure.
- It is recommended to conduct a small-scale test before cutting and welding to confirm the results before proceeding with further processing.
- It is advisable to first use spot welding to secure key points, and then proceed with continuous welding.
Comments
