BVP-3D
Report

keychain of a basketball, with club moon and player name

Instruction
basketbalSleutelhanger.xcs
basketbalSleutelhanger
.xcs
Application scenario
Laser processing
Machine & module
xTool P2S
55W
Compatibles · 9
Accessories
xTool P2 Honeycomb Panel
Material used
3mm Pale red mirror Acrylic
2
127
Information
      keychain of a basketball, with club moon and player name. make with 3mm mirror acrylic. 
    
Instruction
1
Step1: place of the mirror acrylic

place the mirror acrylic on the bottom. Make sure that the back of the plate is facing up.

NEVER engrave the mirror side! This will damage the laser.

2
Step2: Change naam in XCS and turn
Preview
Preview

change the imageto mirror by reflect horizontal function in XCS

You can change the nameof the name of the club and the name of the player.

After that change the image again with the same function in XCS

3
Step3: Go start

Start the task. After complete. clean the basketball on the back and remove the protective plastic from the front. then you can put a chain or a key hanger in the hole.

Comments
Remixes
xTool Supplies Used in This Template
xTool P2 Honeycomb Panel
xTool P2 Honeycomb Panel
xTool P2S
xTool P2S
3mm Pale red mirror Acrylic
3mm Pale red mirror Acrylic