Report
Personalized Pet Paw Ornament with Name
InstructionOrnamentDog
.xcs
Application scenario
Laser processing (10min)
Machine & module
xTool M1
10WCompatibles · 10
Material used
3mm Basswood Plywood
53
230
Information
Personalized Pet Paw Ornament with Name . Made with 3mm bassewood plywood in Xtool M1
Instruction
1
Step1: Design
Preview
Open the Ornamentdog.xcs file in Xtool Creative and you will have the Keychain
2
Step2: Cutting Setting
Preview
The file is set for 3mm Basswood Plywood with Triangular Prism. If you want to use 6mm Basswood you have to change the speed to 3mm/s and pass to 3
The cut layer is red and is set for Xtool M1 10W, you can change this option depending on the machine (if it uses a 20W laser it would require a higher speed). You can also modify the parameters depending on the material such as plywood, acrylic or any other material you have available
3
Step3: Engraving settings
Preview
You can modify the power or speed of the engraving to achieve a greater or lesser degree of engraving.
The dog's name must be changed. The font can be changed if desired.
4
Step4: Place Ribbon
Preview
Add the ribbon of the color you want.
Comments
Remixes
xTool Supplies Used in This Template