Honeycomb Bed Pins - S1 Honeycomb

Information

      As much as the Magnetic Pins included with the machine are great, there are times when thy don't quite do what you need, so I have put these together - 39 x S1 Honeycomb Bed Pins  Created on a A4 size 297mm x 210mm (Border can be switches to not Output - Was just added to ensure fitment)

Number of Pins can be added to easily depending on the size of your material

**DO NOT SCALE THE PINS ** of they will not fit the honeycomb as intended.

As you can see in the photo - they are a nice snug fit and really hold the material down - they can be fitted horizontally if you wish although the sizing of the honeycomb is not uniform so they may be a bit tighter.

Normal XCS material setting should work - Power 100%, Speed 15mm

I have not added any instructions as this is pretty simple to use - just add the project and ensure the material and setting are correct.
If you do not have the exact size material - Use the Mark Processing Area and mark out what you do have, you can then move these Pins into your marked area and you will be good to go - If you have any that are outside the of your marked area, Right click and ungroup - then select the ones that are outside your material - you may find they fit somewhere else on the marked area but this will depend entirely on your material and marked area.

Remember - DO NOT RESIZE THEM OR THEY WILL NOT FIT.