Import the file into the XCS software.Remove the machine baseplate, put the raised pillars at the bottom of the machine. Use the rotary attachment clamping the beer glass and put it into the center of the machine and start focusing. Ensure that the engraved pattern is located in the center of the beer glass with the handle through the cross cursor and framing.

Notes

1.The pattern should be placed in the center of the beer glass with a handle before engraving, whichever is based on the leftmost of the pattern.

2.Pay attention to the position of the handle with the beer glass to avoid affecting the work of the laser.

3.Put the beer glass with the handle in water for one minute after engraving and then tear off the colored paper.It can avoid damage caused by scraping the colored paper.

Take out the engraved beer glass with handle of the machine.