Cute Wooden Bunny Decoration By KBWILD
Instruction
I was thinking of Spring time designs for crafts for a craft fair I had last month and I created a Simple 3D bunny with a stand.
Cutting and building this little bunny is quite simple. There are 3 pieces that make up this bunny.
- The Bunny outline
- The solid bunny cut-out
- The stand
Note: Discard the piece of the inner bunny the stand was cut into, this was to save material
After cutting out the 3 pieces
I painted them as this was easier to do before rather than after and you can touch up any spots later if you missed any.
I like to use super glue as it dries quickly.
Glue Pieces #1 onto piece #2
Clamp it down and Wait until the glue is dry.
Glue the pegs on the bottom of piece #2 into the holes in piece #3.
Note:
These pegs are sized properly fr use with 2mm wood and if you want to use a different size wood you will need to adjust the height of the pegs on Piece #2 and the Height and the holes on piece #3
For example if you use 5mm wood.
The pegs should be 5mm in Height and the width of the holes in piece #3 should be 5mm as well.