HomeTemplatesTools & Special MaterialsJigs
donnydanni
Report
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Project made with xTool D1 Pro machine for Laser cut and engrave.
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave
Laser cut and engrave

Honeycomb base riser legs

Instruction
laser honeycombe support stands.xcs
laser honeycombe support stands
.xcs
Application scenario
Laser (20min)
Machine & module
xTool D1 Pro
10W
Compatibles · 8
Material used
Birch Plywood
317
3298
Information
      risers to place under the honeycomb to save the regular fitting and unfitting of the leg extenders when switching between the rotary and flat laser work. Easy to scale for different heights! Very Easy!
Instruction
1
Step1: Resize the parts to your needs
Preview

resize the parts by selecting the parts together and dragging the top centre point only either up or down and unlock the padlock first to keep slits the right size and the base large enough to keep them stable!

This set is about 91mm tall and 80mm wide at the base, only change the height!

2
Step2: Cut the required number of parts
Preview

cut the parts, for the d1 pro 10w i used 100% power at 4 mm/s speed for 3mm birch plywood

3
Step3: slide the parts together
Preview

slide the 2 parts together as shown in the image

4
Step4: glue if required (optional).
Preview

Run a bead of Ca glue down the joint if required but not essential

5
Step5: place under honeycomb
Preview

Use the parts as shown

Comments
Remixes
xTool Supplies Used in This Template
xTool D1 Pro
xTool D1 Pro